Ethernet and Telephone Extender Extend Ethernet and Telephone Data Connect 2178HSEE Ethernet and Telephone Extender
Now your can extend Ethernet over your telephone cable...without sacrificing the telephone! Ethernet and Telephone can be extended over a single copper pair simultaneously
FEATURES • Voice and data communication can be shared simultaneously over the existing telephone wire • One box design, CO / CPE selectable via DIP Switch • Defines symmetric band plan for the transmission of upstream and downstream signals • Complies with IEEE 802.3, 10Base-T, IEEE 802.3u, 100Base-TX and IEEE 802.3x, Flow control E. standards • DMT (Discrete Multi-Tone) line coding • Half duplex Back pressure and IEEE 802.3x Full Duplex Pause frame flow control • One RJ-11 connector for VDSL port with VDSL connection, additional Splitter for POTS connection • Cost-Effective VDSL2 Profile 17a/30a CO / CPE Ethernet extension solution • One 10/100Mbps RJ-45 port, Auto-Negotiation and Auto-MDI/MDI-X • Supports up to 1536 bytes packet size, IEEE 802.1Q VLAN tag transparent • Simple Plug-and-Play • Selectable target profile and target SNR margin • Supports extensive LED indicators for network diagnosis • Compact size, easy installation
The Data Connect 2178HSEE is a high speed 100/100Mbps Downstream / Upstream, Ethernet Extender. The DCE 2178HSEE is designed based on two core networking technology, Ethernet and the latest Very-high- data-rate Digital Subscriber Line. Our technology offers absolutely fastest data transmission speed over existing copper telephone lines without the need of rewiring. The DCE 2178HSEE supports ultra-high performance to the pervasive telephone line network with up to 100/100Mbps symmetric data rate within 300m and 50/2Mbps for 1.4km long range connections.
The Data Connect 2178HSEE is a plug-and-play design and is fully compatible with all kinds of network protocols. Moreover, the operating status of each individual port and the whole system can be easily viewed via the diagnostic LEDs on the front panel. The DCE 2178HSEE offers two modes, CPE and CO, for application: CPE mode is used at client side and CO mode is at central side. The CPE or CO mode can be selected by using a built-in DIP switch. In a point-to-point configuration, there must be a CPE mode on one side and a CO mode on the other side to perform a seamless Ethernet connection. When the DCE 2178HSEE is in profile 17a operation mode, it provides long distance Ethernet transmission. When the DCE 2178HSEE is in 30a operation mode, it provides short distance Ethernet transmission with higher speed performance in upstream and downstream traffic.
ORDERING INFORMATION DCE/2178HSEE-2PK DCE/2178HSEE
